床面固体颗粒圆柱绕流的试验现象观察

本文介绍了床面固体颗粒随水流绕过圆柱体时，将在圆柱周围的床面上形成一个无粒子运动区的试验现象。水槽试验结果表明，当固体颗粒的粒径减小时，无粒子区的范围将增大；无粒子区的范围随圆柱直径的增大而增大；水流条件的变化直接影响着床面固体颗粒的运动情况，同无粒子区的形成、消失及范围大小有密切的关系。根据试验资料，结合量纲分析，建立了无粒子区的无量纲经验关系式     

圆柱绕流的非线性动力学

本文利用非线性动力学的概念和方法来研究粘性不可压缩流体的二维圆柱绕流问题．计算了定常流失稳以及出现混沌的临界雷诺数，并估计了混沌解的一些统计特征．     

Optical investigation of the heat transfer from a rotating cylinder in a cross flow

The heat transfer from a rotating cylinder in an air-cross flow was investigated by purely optical measuring techniques. Flow velocities were measured by a two-dimensional LDV both in the vicinity of the cylinder and in the boundary layer. A new optical device based on light-deflection in a temperature field was developed to examine local temperature gradients in the boundary layer of the rotating cylinder. Finally, a Michelson-interferometer was installed to produce real-time pictures of isothermal lines around the heated cylinder. The impact of rotation on flow patterns, boundary layer behaviour and heat transfer could be clearly identified. It appears that the velocity-ratio acts like an independent parameter, in that flow patterns correspond to this dimensionless number. Furthermore, it seems that rotation dominates over cross flow, both fluid-dynamically and thermally above = 2.This work was carried out at the University of the Federal Armed Forces in Munich/Germany.     

多层电磁弹性圆柱壳内波的轴向传播

对多层电磁弹性圆柱壳内波的轴向传播进行了分析。根据柱坐标系下电磁弹性多层结构的几何方程、平衡方程和本构方程,推导出了两个层间变量所满足的状态方程。通过状态方程的解和层间变量连续性条件,得到了多层圆柱体内外表面层间变量的传递关系。最后利用边界条件,导出了波在传播时所满足的频散方程,并求得该结构的模态参数。以一个三层的压电/压磁材料组成的柱壳结构作为数值算例,计算出波在其中轴向传播时的频散关系和模态参数,并对计算结果进行了分析。     

线性强化材料厚壁圆筒的统一极限分析

运用统一强度理论对承受内压的拉压屈服强度不同的线性强化材料的厚壁圆筒进行了极限载荷分析，得到了适用于多种材料的厚壁圆筒极限载荷的统一解析式．     

Influence of corrugation frequency and amplitude on the stress state of hollow elliptic cylinders

The influence of corrugation frequency and amplitude on the displacement and stress fields is analyzed based on an approach to solving stress problems for corrugated elliptical cylinders with certain end conditions.Translated from Prikladnaya Mekhanika, Vol. 40, No. 9, pp. 87–93, September 2004.     

基于VLES模型的振动圆柱数值模拟

本文将一种VLES(Very Large Eddy Simulation)模型引入到动网格数值计算中,并验证了VLES模型用于模拟类似振动圆柱绕流的动边界问题的有效性。数值求解了不同振幅和频率下非稳态振动圆柱绕流问题。研究表明:随着振幅和激励频率的增加,绕圆柱流动涡脱离形式从2S模式转换到2P0模式,再到P+S模式。在高振幅和激励频率比fe/fs=0.95时,涡脱离形式却表现为2P0模式到P+S模式的过渡状态,振动圆柱在上升或下降过程中涡的脱离造成在每个周期升力曲线的左右侧发生不规则的"跳动"现象,尽管脱落涡可能为涡对或者单涡.     

Dispersion of elastic waves in the contact-impact problem of a long cylinder

Numerical dispersion of two-dimensional finite elements was studied. The outcome of the dispersion study was verified by the numerical and analytical solutions to the longitudinal impact of two long cylindrical bars. In accordance with the results of the dispersion analysis it was demonstrated that the quadratic elements showed better accuracy than the linear ones.     

Comparison of adjustable permanent magnetic field sources

A permanent magnet assembly in which the flux density can be altered by a mechanical operation is often significantly smaller than comparable electromagnets and also requires no electrical power to operate. In this paper five permanent magnet designs in which the magnetic flux density can be altered are analyzed using numerical simulations, and compared based on the generated magnetic flux density in a sample volume and the amount of magnet material used. The designs are the concentric Halbach cylinder, the two half Halbach cylinders, the two linear Halbach arrays and the four and six rod mangle. The concentric Halbach cylinder design is found to be the best performing design, i.e. the design that provides the most magnetic flux density using the least amount of magnet material. A concentric Halbach cylinder has been constructed and the magnetic flux density, the homogeneity and the direction of the magnetic field are measured and compared with numerical simulation and a good agrement is found.     

旋转液体中固体颗粒运动的进一步讨论

通过分析旋转液体中的压强分布,说明了浸在液体中的固体颗粒向轴心运动的原因,以及该规律的实际应用.